Beovision 7 32 VESA bracket / plate

This VESA plate or VESA bracket is specially designed to mount on a floor stand, wall holder or table stand from Beovision 7-32 or Beovision 6.

The VESA bracket fits TVs with both 6 mm and 8 mm screws.

How to attach the VESA bracket

Remove the current B&O TV on the Beovision 7 stand by loosening 2 screws. Mount the VESA 200/300 plate (bracket) on your TV and then mount the plate with the TV on the stand.

How to install the VESA plate on the BV 7-32 stand - click here

How to choose the right VESA plate - click here

What are the dimensions of the VESA plate / bracket for the Beovision 7 stand

• The VESA plate has 200 and 300 mm hole spacing on the side and has holes intended for a maximum of 8 mm screws (M8) on your TV.

  
  
• The VESA bracket also has a height distance of 300 mm, where the hole distance jumps by 25 mm.
  
  
• The product is prepared for mounting the Neo 7 Adapter, where holes have been prepared.

  
  
• A bag is included
• 2 pcs M5 (5 mm) screws for mounting the Neo 7 Adapter on the VESA plate.

• 2 pcs M5 (5 mm) screws to fasten the VESA plate on the B&O stand.
• 4 pcs M6 screws (6 mm), 4 pcs spacers of 10 mm for mounting between the TV and the plate.
• 4 pcs M8 screws (8 mm) and 4 pcs spacers of 10 mm for mounting between the TV and the plate (used for Samsung TV)

Attach the Neo 7 Tilt Stop to the stand

The original TV from Bang & Olufsen was made completely in balance, but modern TVs are not. They often have the electronics at the bottom and therefore most of the time at the bottom of the TV.

This means that your TV tilts or tilts on a Beovision 7 stand, so that the TV is in a non-vertical position.

Here, use the Neo 7 Tilt Stop to get the TV in a vertical position again.

Neo 7 Tilt Stop is made of plastic and very easy to install. Put your TV in a vertical position and carefully mount the plastic unit between the VESA plate and the Beovision 7 stand.

Buy it here at Neo Shop.